- This topic has 8 replies, 2 voices, and was last updated 1 year, 2 months ago by Jonas.
- 8 June 2018 at 12:50 pm #188845JonasGuest
Karma at Castle Rock has been re-bolted. The previous bolts were dangerous which most people believed were glue-in machine bolts, however all were bash-in carrots with a small amount of glue around the stem to stop water ingress. 3 of the boltheads were 3mm smaller than the standard carrot which meant the bolt plate could come off when using nearly all modern karabiners.
All bolts were replaced with glue-in ring bolts. The placement of ring bolts at a popular tourist attraction wasn’t done without careful consideration and use of appropriate gear. Low profile, non-shiny, stainless ‘P’ bolts were used with Hilti glue matching the rock colour and all were further camouflaged. 2 x anchor bolts were also placed at the top about 1 – 1.5m back from the edge for a rappel, top belay or top rope (with an extension) which are out of view from the skywalk.
The result is a very inconspicuous route which, when done properly, busts the myth that ring bolts are too high profile for areas frequented by tourists. The work was done by Olly Morell and myself and supported through the CAWA re-bolting fund.9 June 2018 at 11:49 am #188849Tony BrebnerGuest
Nice job Jonas & Olly. Gives us low graders a chance to climb one of the most iconic climbs in a great location. Many Thanks.11 June 2018 at 10:11 am #188850GeorgeGuest
Great works lads!.
Well considered and fantastic that the bolting fund is supporting this work. Thanks3 July 2018 at 7:13 am #188896Paul Ryan DonovanGuest
Thanks guys great work!4 July 2018 at 6:06 pm #188920Dirk KlickerMember
Awesome.4 July 2018 at 6:06 pm #188921Dirk KlickerMember
Awesome.16 July 2018 at 1:42 pm #188948kimGuest
Good stuff. Glad to hear so much thought has gone into visual impact as what people do not see does not bother them.28 February 2019 at 3:46 pm #189457GideonGuest
Hey Jonas, good job.
Wondering which glue you used. I have the equipment for hilti re500 but if I can use a better colour epoxy with the same application gun I’m keen to know.
Thanks23 March 2019 at 6:31 pm #189488JonasGuest
Pretty sure it was the Hilti HIT-HY 200-R which is grey. It uses the same dispenser and nozzles as the RE-500 which I normally use but RE-500 is pink-redish in colour. I reckon RE-500 is still the best if the colour is not an issue, although it does fade in time.